2011 Nissan Xterra

//2011 Nissan Xterra

2011 Nissan Xterra

Nissan Xterra

Mileage
118,296
Service Date
8/19/2022
Services Performed
  • CHECK AND ADVISE : CONFIRMED CUSTOMERS CONCERN, ENGINE STALLS. SCANNED VEHICLE FOR CODES AND FOUND P0335, CRANKSHAFT POSITION SENSOR CIRCUIT. INSPECTED CRANKSHAFT POSITION SENSOR WIRING AND DID NOT FIND ANY FAULTS AT THIS TIME. TESTED CRANK SENSOR AND FOUND SIGNAL ERRATIC. RECOMMEND REPLACING CRANKSHAFT SENSOR AND RECHECK. CLIENT ADVISED, CLIENT APPROVED ALL RECOMMENDATIONS
  • FRONT __35____ REAR ____35__
  • CRANKSHAFT POSITION SENSOR – Remove & Replace
  • REPLACED THE POSITIVE TERMINAL AND CLEANED BOTH TERMINALS AT NO CHARGE
  • ALL FLUID LEVELS OK AT THIS TIME – NO CHARGE
  • STEERING GEAR (COMPLETE) – Remove & Replace – 4WD – [Includes: Adjust toe-in on Rack and Pinion type Steering Gears. NOTE: Deduct .4 if alignment is also performed. DOES NOT include transfer of components.]
  • Inspect all hydraulic line and hoses. Inspect calipers and wheel cylinders. Inspect master cylinder and cap. Flush entire brake system including master cylinder, calipers, wheel cylinders until clean.
  • Hazardous Waste fee
 
EDWARD L. gave our service a 5 star review on 9/2/2022
2022-09-03T21:59:24+00:00